Grouping attributes into tabs: Difference between revisions
No edit summary |
m clarifying whats for what |
||
| (One intermediate revision by the same user not shown) | |||
| Line 4: | Line 4: | ||
The [[atkTabbedPane]] attribute allows addition of subtabs to forms. | The [[atkTabbedPane]] attribute allows addition of subtabs to forms. | ||
Sections will create a node level tabbed pane. This how to is for tabs as an attribute. See: [[Grouping attributes]] | |||
== Requirements == | == Requirements == | ||
| Line 42: | Line 44: | ||
== FAQ == | == FAQ == | ||
<strong>How do I remove the tab label? | <strong>How do I remove the tab label? and How do I make the tab set extend "full width"?</strong> | ||
Check out the [[ATK Attribute Flags]] AF_NO_LABEL and AF_BLANK_LABEL | |||
== Contact == | == Contact == | ||
Latest revision as of 10:10, 7 December 2008
|
ATK Howto: Grouping attributes into tabs
|
Summary
The atkTabbedPane attribute allows addition of subtabs to forms.
Sections will create a node level tabbed pane. This how to is for tabs as an attribute. See: Grouping attributes
Requirements
ATK 6.0+
Implementations
1. Include the attribute like you would any other attribute:
useattrib("atktabbedpane");
2. Add attributes to atkTabbedPane
The general constructor of atkTabbedPane is:
atkTabbedPane (String $name, [Array $tabs = array()], int $flags)
- String $name: The name of the attribute
- Array $tabs: The arrays looks like array("tabname1"=>array("attribname1","attribname2"),"tabname1"=>array(..),..)
- int $flags: The flags for this attribute
For example if we had a node with the following attributes:
- name
- age
- address
- comment
And we wanted to have name and age on a single subtab and address and comment on a separate subtab at the same level, we would use atkTabbedPane as follows:
$this->add(new atkTabbedPane("mySubTab", array("name_age"=>array("name","age"), "add_com"=>array("address","comment")) ));
3. Test
If everything was done correctly, when we refresh the node, we should see two subtabs: name_age with attributes name and age and subtab add_com with address and comment attributes.
FAQ
How do I remove the tab label? and How do I make the tab set extend "full width"?
Check out the ATK Attribute Flags AF_NO_LABEL and AF_BLANK_LABEL
Contact
Jorge Garifuna http://www.GariSoft.com